Want to remove ads? Become a MK3OC Club Member today!

Latest activity

  • djwilly
    djwilly reacted to Todd100's post in the thread Todd100's Ph1 GSi with Like Like.
    A little bit more done, rear beam, shocks, springs etc all fitted along with back box after a good polish
  • Todd100
    Todd100 replied to the thread Todd100's Ph1 GSi.
    A little bit more done, rear beam, shocks, springs etc all fitted along with back box after a good polish
  • Wetandwindy3
    Looking for a standard saloon rear bumper( condition not Important only need the middle inner frame) or even better a 200ts rear, also...
  • Todd100
    Todd100 reacted to TomF's post in the thread Brake bias / proportion valve with Like Like.
    I think the 3/20 is the fixed restriced ratio.. Mk2 GTE 16v non ABS had the same valves but they are very hard if not impossible to...
  • TomF
    TomF reacted to DavebGsi's post in the thread Dave b's VXR Powered Gsi Diary with Like Like.
    I also got this done, standard thermostat housing, had a boss welded on it so I could fit a dry break connector for an engine heater...
  • TomF
    TomF replied to the thread Phase one GSi rear brake valves.
    Yes mate pedal push rod into servo, theres a lock nut to undo the turn the rod to adjust then retighten nut :thumb:
  • TomF
    TomF replied to the thread Brake bias / proportion valve.
    I think the 3/20 is the fixed restriced ratio.. Mk2 GTE 16v non ABS had the same valves but they are very hard if not impossible to...
  • Wetandwindy3
    Wetandwindy3 replied to the thread Repair panels.
    Thanks will have to search around, maybe I’ll come across a 200ts bumperI wish!
  • Todd100
    So my Gsi has the rear beam valve which in my infinite wisdom I decided to take apart and clean up, didn't go well.... I have found a...
  • DavebGsi
    DavebGsi replied to the thread Repair panels.
    have a look on ebay mate and do a google search, ive seen the saloon panels around
  • Wetandwindy3
    Wetandwindy3 replied to the thread Repair panels.
    Looking for a lower subframe x member and complete front panel, few wee bits too, don’t think they do a saloon rear panel, might have to...
  • Todd100
    Todd100 replied to the thread Repair panels.
    I've had sills from them and I would say they are fairly decent size and shape, close enough anyway for repairs
  • DavebGsi
    DavebGsi replied to the thread Repair panels.
    what are you after? i got the side sills and there were alright, good quality metal aswell, cant comment on shape as i only used a section
  • Wetandwindy3
    Wetandwindy3 replied to the thread Repair panels.
    Thanks for the replies guys, checked out that carbodypanrls4u stuff but don’t know what the quality is like? Fed up of getting pattern...
  • DavebGsi
    DavebGsi replied to the thread Ricks Arctic 24v.
    Do love this car, VBOA 21?
Top